MevaDec: The All-in-One Slab Formwork

Support: Primary beams and props with drop heads

• Simple assembly and stripping, low learning curve and shorter assembly time

Grid-free placing and moving (in millimeter precision) of panels in primary beam, over and beyond drop head

• Simple, grid-free adaptation to building geometries

Free changing of forming direction

• Improved safety, avoids assembly errors, avoids superfluous props, fewer parts

Number of props determined by the System  

• Few props required

Support: Primary beams and props with drop heads

• Free choice of facing to best match the slab’s geometry

Separate facing placed on primary and secondary beams

• Primary and secondary beams support separate facing

Free placing/moving of secondary beams in primary beams

• Very few props required

Without primary and secondary beams

• Ideal for buildings with small slab areas where early stripping is not required
  

Just two parts: panel and prop with prop head

• Small inventory, simple handling

One prop head for all uses, fits corners and edges; also used to support the cross stiffener

Panel width 40, 60, 80 and 160 cm; panel length 80 cm and 160 cm; frames made of closed 2-chamber aluminium hollow profiles with high-quality annealed powder coating

• Simple adaptation in 20 cm increments – compensations are always less than 20 cm

Primary and secondary beam

• Stable and torsion-proof, for stepless change of direction

Prop with drop-head allows for early Stripping

• Less inventory through repeated re-use

Lowering of primary and secondary beam through drop head system with uplift protection of primary beams

• Easy and fast, reduces assembly Errors
• Beams are held securely and cannot fall down
• Reduces wear and tear, improves safety

Drop head lowers by 19 cm

• Fast, easy Stripping

Props remain as reshores / backpropping

• Safety and very short cycles

Panels and beams are ready for re-use in next cycle

• Less inventory, simple handling, cost-saving

Up to 34 cm thick slabs achievable with primary beam 210.
Up to 44 cm thick slabs achievable with primary beam 160.

• Fewer props leave more space for easy working
• Only 0,27 props per m² with primary beam 210 (stand. appl.)
• Only 0,35 props per m² with primary beam 160 (stand. appl.)

All-plastic facing alkus

• No re-facing, consistently superior concrete finish, easy cleaning using high-pressure washer up to 1000 bar